Amana Dryer Repair

It tumbles but there is no heat. Heating element, thermal fuse or the high-limit thermostat. The half that matters is why: a thermal fuse blows because airflow was restricted, never by itself. Fitting a new one without clearing the duct means it blows again, so the vent is checked as part of the job.

Cycles take two or three times as long as they used to. Restricted venting almost every time — and a genuine fire risk rather than an inconvenience, which is why a slow dryer is a same-week booking.

There is a rumble, thump or squeal that keeps getting worse. Drum rollers, the idler pulley or the belt. Caught early it is a routine parts job; ignored, a snapped belt can wrap the drum and damage the bearing.

The drum will not turn but the motor hums. Broken belt or a seized roller. The motor is fine — it is trying to drive something that will not move.

It runs and heats but the dial never advances. The mechanical timer. On a simple dryer this is a discrete, replaceable part rather than a board, and swapping it restores the machine outright.

It is completely dead. Door switch, thermal fuse or the timer. On a gas Amana the igniter and flame sensor come into it too. Door switch first — most common and least expensive.

If the washer has gone at the same time, Amana washer repair covers it.