JennAir Dishwasher Repair

It will not drain and water is sitting in the tub. Drain pump, a blocked filter, or the hose kinked behind the cabinet. This is the single most common dishwasher call we take on any brand, and the cheapest of the causes is also the most likely.

Dishes are coming out dirty or gritty. On a JennAir the TriFecta wash system runs multiple spray arms working together, so a blocked or seized arm takes out a whole zone of the rack rather than degrading the wash evenly. If one section of a load is consistently worse than the rest, that is the place to look first.

The load is coming out wet. Heating element, the thermostat, or the vent that releases moisture at the end of the cycle. Plastics staying damp while everything else dries is normal; the whole load staying wet is not.

There is water on the floor. Door seal, a hose connection, or the pump housing. On a built-in unit a slow leak runs into cabinetry and subfloor for weeks before it shows anywhere you would notice, which is why this one is worth booking rather than watching.

Nothing happens when you press start. Door latch switch, the control board, or power to the appliance. The latch is checked first because it is both the most common cause and the least expensive to put right.

The cycle runs far longer than it used to. Usually a heating fault. The machine keeps extending the cycle waiting for water that never reaches temperature, which is the appliance compensating rather than malfunctioning — but the underlying element or sensor still needs replacing.

If refrigeration or cooking has gone at the same time, JennAir refrigerator repair and range repair cover those.